MSefi.com read only forum (Jan.15,2018)

you can use gm coils for a Ford EDIS module. to do so, get the base however they mount to. remove the internal computer that is under the coils (I did this with a V8 with a caddy northstar coil pack) you then should have little tabs sticking out from under the plastic. these are the connections to ...

:yeah!: YEA!!!!! it fired the first time today!!!! however can't keep it running. BUT! it fired. and seems to be firing correctly. as all of the exhaust headers were getting hot and pretty evenly.

I needed to flip the wires around for the crank sensor. thankfully I know how to disassemble the ...

hmm.. maybe i'll try flipping the sensor around. as this post shows


Re: EDIS-6 and no sparky?

New postby CygnusX1 on Wed Sep 10, 2008 10:53 am
It turned out that the module was good. After I connected all six spark plug wires and reversed the VR wires for the third time, it sparked. Now I don't ...

Hi,

EDIS is sensitive to spark circuit resistance and /or very fouled-shorted plugs.

Make sure that you have at least 5 kOhms in each HTlead-spark plug. Use good quality resistor plugs,
they are usually 5 kOhms and/or resistor HT wire. :D

The internal circuitry in EDIS evaluates the spark ...

I finally went to crank the car over today. however i think I have a ford EDIS problem.
I start cranking, megatune shows about 180 rpm or so for the first second of cranking. then it goes away.
if i try to crank from the key's run position i get no rpm signal showing in megatune.

If I cycle the ...

so in using the GM pack just jab something in the slot, for wire one and something in the other slot for wire 2? there is no other connection to these coil packs?
using MS2 V3 board

-nate

I don't think you can use the fuel pump relay, dosen't MS have a timer to run the fuel pump for only about 2 seconds from inital key to on then it turns off. then MS waits for an ignition signal to turn the pump back on?

-nate

The manual refrences MS-1 v2.2 main board.
does V3 requre resistors for the injectors? the V3 has a flyback design to it. I do not see this refrenced in the manual or the assembly instructions of the v3 board.

any help would be appricated.
-nate