MSefi.com read only forum (Jan.15,2018)

Thanks for the info. on the connectors. Those places had just what I needed.

Thanks,

George

I bought it off of Ebay several months back. I have disassembled it and put it back together. It is a 700 cfm w/ 60pph @ 12 psi. 4-bbl. I have found the connector for the TPS and the IAC, but I am still looking for the 5 pin Weatherpak connector for the fuel injection. I probably going to contact ...

I have been checking out Jeg's, Summit, and Ebay for these connectors. I am going to call Holley to see what they have to say. I am hoping that the sensors are made by on of the THREE big auto maker, rather than Holley specific.

Thanks,

George

I have used the LM-1 and O2 sensor to set the AFR on the existing Holley Pro-Jection system that I have on the car now.
The Pro-Jection syatem does not deliver enough fuel above 4K rpms. I have a large selection of tools in my shop. I do have a fuel pressure gauge and a Volt-Ohm meter.
Where can I ...

Thanks for your response. I have done a lot of reading about the tuning of the MegaSquirt setup that I have. My brother is bringing his laptop over this weekend so that we can see if we can get the tuning down to an art. I know there is a LOT to reading and research that I am going to do. What I was ...

I have had the MegaSquirt II EFI on the shelf in my shop for about 10 months. I decided that it was time to install it on my '69 Z/28. My son bought this for me for my birthday last year. He is in Iraq repairing helicopters on a Marine base. If he was here he could help me with this project. Since ...