MSefi.com read only forum (Jan.15,2018)

Mercedes S class came with airbags from 1981, and should then be a great candidate. I have not checked when they came with abs, but if it was before 1985 then it is also one plus. 280 SE is the ones they produced most of, they have M110 engines of 2.8 liters. M110.92x and .93x is carbureted engines,...

There is a calculator here that is very good:
http://dairally.net/daihard/chas/MiscCa ... rottle.htm

Getting megasquirt to pass emissions is a no problem,but getting the government to approve.. There is an enormous amount of hearsay about this, and speaking to people at the motor vehicle inspection stations often yield different answers and/or they don't know how to deal with it. However, as far as...

Yes, we've got a couple dyno charts from our Nova project. 1. Swap carb for TBI, distributor with performance recurve kit controlling ignition: http://www.DIYAutoTune.com/tech_articles/megasquirt-carb-to-efi-part1-nova.htm 2. Have the ECU take control of the ignition: http://www.DIYAutoTune.com/tec...

ill disconnect that wire then, or leave the green/vio unconnected. i am going to keep the original wiring loom compatible with the stock ECU.

My wiring is with different colours: 1. black/brown 2. brown/black 3. black 4. to ground 5. 6.green/vio megasquirt sends +5vdc along the 5vref wire to the tps unit, and a return signal is sent to MS on the tps wire. My question is, is it likely that the switch on that TPS unit will cause any wrong v...

Hello, does anyone have any charts on a 383-350 cid V8 engine (stock intake, exhaust system, stock valve heads),with a carb versus a TBI install ?

Can this one be used with a 36-1 wheel, mounted on the crank shaft ? http://www.motec.com.au/image_display.php?path=2199834_57101.jpg Data: http://www.motec.com.au/filedownload.php/?docid=1309 A alternative is this one, it has 3 wires, so i think it is a Hall sensor. http://cgi.ebay.com/ebaymotors/C...

8974Ollie wrote:No, it uses the 36-1 trigger wheel.

i mistyped, it should have been:

Can megasquirt run EDIS/COP with only a crankshaft sensor ( 36-1 trigger wheel ) ?

Can megasquirt controll EDIS/COP wit just a camshaft sensor ?

Does anyone know where i can get gold of the 35 pin plug that is mounted in a Motronic ECU ?
The plug that is connected to the engine wiring loom looks like this:

kholman wrote:I think it was from 78Spit1500Fed but he hasn't seen here in a while.

That's sad.

I think someone should make a cuddly megasquirt mascot, perhaps a squid will do fine ? A squid to change color to suit its surroundings, and adapt it's texture to mimic corrals. A squid uses jet propulsion. it should be available at the web shops that sells megasquirt kits or finished boxes. I have ...