MSefi.com read only forum (Jan.15,2018)

I gave you wrong information. It was thinking of the R43 I have jumpered. I have the top hole of C30 (the one towards the heat sych) that is jumpered to S12C. Here is the complete list of jumpers I have installed.
R38
R37
R43
D1
D2
ING to JS10
Upper hole of C30 to S12C
OPTOOUT to TSEL
XG1 to XG2 ...

It is not present, but it is jumpered as per build instructions. I started my troubleshooting. I started at the VR sensor. The gap is set correctly. I disconnected the connector at the EDIS module. hooked-up a multi-meter to pins 5 and 6, and rotated the motor. I got a strong AC voltage signal at ...

I'm not sure if I've made things more complicated or not. I went back into the ECU (MSII V3) to double check my assembly. This is what I have. I'm looking for some feedback as to whether or not this is correct. This mod is for EDIS with full fuel control. I'm still not getting any RPM signal to the ...

Sorry about that last post. Trying to do to many things all at the same time. I did indeed use the opto circuit during the build. I however never got a very strong RPM signal useing the stim. The reading was always hit or miss. I'm hopeing at this stage that it's just the VR sensor or wiring. It ...

No problems here. It would be great to share information. I don't know if I would be moving fast enough to really help though. Between work and coaching my days are full. Usually I do my builds and troubleshooting on my off days when they happen. It's been a slow process so far. With that being said ...

Not sure about the spark at this point. I discovered the RPM signal problem as I was checking my Tuner Studio settings after getting a new computer. I've been trying to attack problems as they come up, so I don't lose track of where I am in the process. At this point I figured that if I get the RPM ...

Yes it's a 36-1 wheel. all the EDIS components are from boost engineering. I checked the gap between the wheel and the VR sensor. It could stand to be a little less of a gap, but it's at .045.

Finally getting start my motor after a long build. I have a porsche 2.0L motor with MS2 V3 set up for EDIS and relay board. Megatune shows that I'm getting all the proper gauge reading with the exception of the RPM. It shows no RPM at all, so I know i will get no spark or fuel. I'm thinking maybe ...