MSefi.com read only forum (Jan.15,2018)

Thanks

I will then wire them all back to the groundpins on DB37

Im a bit confused now..

In the megamanual it states that the sensor ground must go to pin 19 at the DB37

in a diagram it goes to pin 7...

and just found another diagram where it goes to PIN 1 + 2..

And finally a diagram where it goes to Enginecase..

What is the best way to have the ...

Just found the answer myself

I will go hunting for a Normal TIP122..

Just recieved and assembled a MS2 V3.0 from DIY

I want to use the PWM idle circuit, but there is no parts for it in the kit, and since i didnt mount the PWM flyback damping circuit i was wandering if i can use the TIP125TU-ND supposed for that ??

Thanks
Martin - Denmark