Hi
I am unable to get a tach signal from my MS board when it is hooked up to the VR sensor. I have MS-II V3.0 main board and am running v2.905 code. When the jimstim is attached to the board, the tach and fuel injection signals work fine. When I hook only the VR sensor up to the board and try to ...
Search found 2 matches
- Wed Sep 26, 2012 6:18 pm
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: Tach signal problem
- Replies: 2
- Views: 373
- Wed Sep 12, 2012 9:32 pm
- Forum: Injectors, Fuel & Air Supply
- Topic: Alternating injector staging not working
- Replies: 1
- Views: 340
Alternating injector staging not working
Hi,
I am using the MS-II with v2.905 code to control an obsolete university project. I have a 2-stroke engine cycle and require the injectors to inject 180 deg out of phase (inj1 pulses at say 90deg, and inj2 pulses at 270). I have the following injection control parameters set, which as far as I ...
I am using the MS-II with v2.905 code to control an obsolete university project. I have a 2-stroke engine cycle and require the injectors to inject 180 deg out of phase (inj1 pulses at say 90deg, and inj2 pulses at 270). I have the following injection control parameters set, which as far as I ...