MSefi.com read only forum (Jan.15,2018)

I figured it out. I had the < and > reversed. Thanks for your help.

Power on value is set to 0 and trigger value is set to 1.

I have my wiring finished and laptop talking to the MS with TunerStudio but haven't started the engine yet. I have configured the FIDLE on pin 30 to switch a temp warning light and pins 25 and 29 to switch a two stage shift light. The problem is when I power up the electrical system and MS, without ...

Thanks again. I learn something new every day.

Thanks, I get it now. I have the choice of using spare digital output pins 25 & 29 and unused pins 30 & 37.

OK, that's one I can use. I'm switching the fuel pump externally so pin #37 is available. Can pin #37 be configured to switch a light? What about using the spare digital outputs on pins 25, 27, 29 and 31?

OK, thanks. I does say "CAN enabled" so I will use pins 3 & 4. I'm not going to be using the idle valve output on pin 30. Can I configure pin 30 to switch a light?

I am just installing a MS V3.57 that was built by DIY AutoTune. I want to switch two shift lights and a water temp light. I just want to confirm that I can use any of the spare pins, 3, 4, 5 or 6 to do this.

When configuring these switches, how do the output port names sync with the pin numbers ...