MSefi.com read only forum (Jan.15,2018)

Thanks i was having a brain fart and forgot about the required fuel fuel .

I was wondering if there was a conversion chart to go from cc per min to grams per second. I need enter my injector flow in the general settings and if i am reading it right it is in grams per second.

Matt thanks for the info i cut off eight of the reluctor points and it runs great!!

thanks i figured i would have to cut down the reluctor.

I hope this msq helps any info would be great thanks mat.

I hope this is what is needed, I included a pic of the dist

Sorry about the lack of info. I am running MS-II 3.0 with v 2.92 firmware with suzuki swift dist, direct coil controll, conected as the manual says,coil + to 12volt off fuel pump relay
coil - to ign output #36, using vr in dist wired to pin#2 and #25. And im not sure how to get my msq over to here.

Hi i am using MS-II V-3.0 on a buggy with a suzuki swift gt 1994 1.3 liter dohc supercharged, it started up fine but the RPM is reading two to three
time's what it actually is,any help would be great.
ps im a newby and i cant type.

I had a question about the 8' harness looking at the V3.0 external wiring diagram the grounds on pins 8,9,10,11 are on pins 15,16,17 and 18 on the harness the diagram does not match the harness.

Dave thanks for the info i figuard the bag dident get labeled,but i found it strange it wasant listed on the parts list in the manual.

I just started building my ms2 v3.0 on step #13 it tells you to install d10 diode is this correct, i do not have a d10 diode and its not on the parts list.