MSefi.com read only forum (Jan.15,2018)

Here is a link to a hi-res photo of the board:

http://i685.photobucket.com/albums/vv21 ... G_3021.jpg

I have a photo of the inside of one of these ECUs and the board is the normal green color and has the B&G markings on it.

I have the car running quite nicely on the crank-fired distributor-less ignition. I also have the coolant temperature sensor and wide band O2 sensor installed in preparation for the EFI bits. I have been trying to figure out the fuel supply and return line issues. I am waiting on a friend who is ...

I got the basic EDIS crank fired ignition system parts installed on the car (VR sensor, toothed wheel, coil pack, and EDIS4 controller). I am able to start the car using the EDIS system default timing of a fixed 10°BTDC. Next is installing the wiring for the Megasquirt ECU into the car and properly ...

So I have purchased two or three new and used MS1 boards from E-bay.
The MS1 boards in black cases are on the v3.0 boards and they have male
DB37 connectors on them so the wiring harnesses available from DIY Autotune
seems to work just fine with them. The MS1 v2.2 unit I have though has a
female ...

Wow, these are great! I have only watched a couple but this is a fantastic resource.
Thanks for putting them up. The page mentions another video being added later.
Any information on when that will be?
--
Steve

Are these high impedance or low impedance injectors? Depending on the type and condition
of these injectors and the circuits necessary to drive them you may want to look at using
something a little newer.

I thought if I had to I could drill a port into the balance tube that runs between the two
sections of the manifold on the North American ZS intake. I don't know the various
benefits or issues around using PWM verses stepper motor IAC. That is something
I have to research. As you say get it running ...

OK, but how do you tell if something that is advertised is indeed a knock-off?
How do I know if someone in Turkey didn't buy some old cache of authentic
v2.2 boards and that is what they are selling?

As an uninformed buyer who does not know the complete list of "good" board
and system distributors ...

What do you mean by Bosch distributor? Are you planning on fitting a different ignition distributor than the OEM Lucas?
I don't see the point of that. I figure that by fitting the coil pack crank fired ignition I not only get better ignition but
I also get rid of the distributor which on every ...

I see quite a few MS1 ECU's ona v2.2 board advertised on Ebay Motors and the listings show that they originate from Turkey.

Anyone know anything about these? Are the counterfit units? They seem to be quite reasonable.

I too am working on adding EFI to a Jensen-Healey. I am in Phoenix. I have my altered manifold almost done and I have gathered things like twin throttle bodies. EDIS bits, throttle position sensors, coolant temp sensors, and etc. I plan on either having the 36-1 teeth cut into the rear edge of the ...