I tried reloading the megasquirt.s19. and I got this message on the downloader.
MegaSquirt Download 2.00
Reading C:/Documents and Settings/Owner/My Documents/MegaSQTS19.File.s19:
Detected MS-I (HC908) code.
Entry point: 0x0000
Code range : 0x8138-0xfffe
File read successfully.
Opened comm port 1 at 9600.
Wake up attempted:
Download failed:
Expected response "
Boot>",
but received this "".
Exception caught: 4
MegaSquirt Download 2.00
Reading C:/Documents and Settings/Owner/My Documents/MegaSQTS19.File.s19:
Detected MS-I (HC908) code.
Entry point: 0x0000
Code range : 0x8138-0xfffe
File read successfully.
Opened comm port 1 at 9600.
Wake up attempted:
Download failed:
Expected response "
Boot>",
but received this "".
Exception caught: 4
I also did all the steps in the http://www.megamanual.com/connect.htm#ms1 page.
has anyone had problems with their MAX232 (U6) or their CPU??
MS Downloader 2.00??
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
timothyalderson
- MegaSquirt Newbie
- Posts: 3
- Joined: Fri Sep 05, 2008 11:38 pm
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: MS Downloader 2.00??
Make sure the boot jumper is firmly in place - I have seen some loops that looked like they were OK but didn't put it in bootloader mode. Sometimes you have to hold it down when you power the unit up.
