Hello, my question is:
Im using an MS2 v3.57 (without coil driver) and im going to change it to an MS2 v3.0 (whith coil driver) May I use the same harness or there is some difference between them?
Regards
DC
MS2 v3.57 VS MS2 v3.0 "Harness"
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: MS2 v3.57 VS MS2 v3.0 "Harness"
The harnesses don't generally depend on the main board, other than what you've hooked to pin 36 since you said you're adding a coil driver. Unless you've got something coming out on the DB15, as that's not normally present on a V3.0.
Re: MS2 v3.57 VS MS2 v3.0 "Harness"
Thanks Matt, pin 36 im using it to Rpm signal ((-) coil) and in the DB15 nothing connected.
regards
DC
regards
DC