I've discovered that I have not been using MLV properly for analyzing my VE table. One of the steps in the MLV HELP for VE Analysis instructs to open the MSQ file, but when I try to open the MSQ file using MLV, it does not look for MSQ files, so I wrongly assumed that it was reading my msq file when I had Megatune opened at the same time. I think this is bad flaw with MLV. Anyway, after I did figure out how to open my msq file in MLV, it gave me the following message:
'The Y axis fields "MAP" not found in current datalog. Set the correct Y axis field from the Options menu for table highlighting and VE Analysis to work correctly."
So when I go to "Options" in MLV and then "Y axis field", in right options, the right arrow points to several options and I don't know which to choose. The options are MAP (which already had a check mark in the box), TP, TP ADC, TPS 8Bit, and Other. Which one should I choose to make MLV work for me?
Thanks for the help.
Gary
MLV question
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.