The DIY Autotune kit has the BIP373 for U16 instead of the VB921 part...
Just a question about resistances... I have basically an open between one outside leg and the center and only about ~400 ohms from the other to center. I used the nylon nut and bolt and the mica insulator... should I have that low of a DC resistance in that circuit?
BIP question
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: BIP question
Which leg has the low resistance?
Re: BIP question
Sorry... I corrected the issue by using the correct insulator. 
On a different topic.. is there supposed to be something in the kit as far as a thermal adhesive for R37 and R38? Am I just missing it? I have all the of the components installed on the heat sink except those two because I think I may have to procure something to couple them to the heatsink.
On a different topic.. is there supposed to be something in the kit as far as a thermal adhesive for R37 and R38? Am I just missing it? I have all the of the components installed on the heat sink except those two because I think I may have to procure something to couple them to the heatsink.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: BIP question
Yes, there should be some small squares of a special double sided tape in the kit.
Re: BIP question
Yeah... didn't see them because I didn't know what I was looking for... just another one of those days. 