Ok im new to this megasquirt thing and am having a hard time getting my truck to run decent. I have tuned my dsm in the past just fine with different tuning tools and this is kicking my butt. I understand afrs and timing as far as tuning. I have done load based tuning with many hondas with chrome and hondata. The truck has a ls1 6.0 with ms1 for fuel control and msd6010 for ignition. It has a zo6 copy cam and a turbo kit on it with stock injectors in it untill I can figure out how to get this to run decent. The truck idles pretty good, free revs a little slow but not too bad. The problem comes when you try to drive the turck. It lacks power bad, Wont accelerate quickly at all and falls on its face basically when you try and go wot or try to get the truck to accelerate quickly. I have adjusted the accel enrichments the best i can, feels ok without a load. Its when a load is applied the truck is a dog. Any and all help is appriated!!! thanks ahead of time Karl-
I have tried attaching datalogs and msq files but it says board attachment quota has been reached, any help with this?
please help, wont accelerate, no power
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
ForumAdminTeam
- Site Admin
- Posts: 78
- Joined: Mon Dec 25, 2006 8:45 am
Re: please help, wont accelerate, no power
mxguy1286,I have tried attaching datalogs and msq files but it says board attachment quota has been reached
Try again, the board limit has been increased and a number of orphaned attachments were removed.
Forum Admin Team
Re: please help, wont accelerate, no power
Thanks for the help!!! files have been added. 
You do not have the required permissions to view the files attached to this post.