Oke, im trying to test my injectors..
First i tryed with the standard 400/20/60 [(squirts)/(pw)/(close)] I did burn it to flash. worked well.
After some test i would try a verry short closingtime. So i set the parameters to 100/50/1 and also burn it. I noticed that ms didnt do anyting, he still used the last test. burn to flash again and then it did. Fist time a short puls from the injector, seems to work. But the next test i did, the injector stays open without giving a pulse and stays squirting (till i am running out of fuel?).
Now i dont get it out of the testmode, the injector stays open all the time. Even when i set te squirt to 0 it wont work..
Injector test mode
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: Injector test mode
Problem solved.
a reboot fixed it.. i could not burn to flash anymore. I gues i've set the pw too short, so it was squirting continuous. Afther that i made a mistake, i was turning it on to 'normal mode' and burned it. Result: I could not burn anyting anymore.
After the reboot i tryed the short pw again and it also was squirting continuously. When i set the pw up to 5 it was squirting with pw. Then i turned it back to normal mode and immediatly it turned back to normal mode. (This never happend before)
I Didnt try to set it to normal mode after the continuously squirt, becouse i was afraid to reboot again..
a reboot fixed it.. i could not burn to flash anymore. I gues i've set the pw too short, so it was squirting continuous. Afther that i made a mistake, i was turning it on to 'normal mode' and burned it. Result: I could not burn anyting anymore.
After the reboot i tryed the short pw again and it also was squirting continuously. When i set the pw up to 5 it was squirting with pw. Then i turned it back to normal mode and immediatly it turned back to normal mode. (This never happend before)
I Didnt try to set it to normal mode after the continuously squirt, becouse i was afraid to reboot again..