Ran across the PWC writeups tonight and read thru them all. Interesting developments that I was not aware of. I do not find reference to the PWC in the Megamanual, so I wonder if it is finished and is offered by B&G for sale?
Anyway, near the bottom of "Wiring and Installation" is this paragraph. The bolded sentence is incomplete -- is antiseize OK to use when installling the sensor?
"Avoid excessive heating of sensor cable grommet, particularly when the engine has been switched off after running under max. load conditions. The use of cleaning/degreasing fluids (thinners or VarSol) or evaporating solids at the sensor plug connection is not permitted. Assembly with special high temperature resistant grease (i.e. anti-seize) on the screw-in thread (e.g. Bosch-No. 5 964 080 112 for the 120g tin). The LSU4 uses the same metric 18mm x 1.5mm threaded bung as virtually all other oxygen sensors, including narrow band sensors. The sensor should be torqued to 30-45 ft·lb (40-60 Nm)."
Brian
Precision Wideband Controller
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Bernard Fife
- Master Squirter
- Posts: 475
- Joined: Thu Oct 29, 2009 12:54 pm
Re: Precision Wideband Controller
Brian,
The PWC has not been completed. The sentence in question should have "assemble" where "assembly" is. I will fix it right away.
Lance.
The PWC has not been completed. The sentence in question should have "assemble" where "assembly" is. I will fix it right away.
Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw