Odd pattern in my VE table
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Odd pattern in my VE table
Last fall, I made several runs datalogging and then performed the VE Analysis in MLV after every run. It was to the point where VE Analysis was making fewer and smaller changes but the pattern of values in my VE table seems odd. See the datalog and VE table from my last analysis in the attached msq file. The values are all over the place, not like the VE table I see in the MS manual. I had acceleration enrichment turned off and EGO turned down low while tuning the VE table. Also, I was using gentle throttle inputs. Should I trust my VE table is good, manually change the values to resemble the patterns of a normal table, or use a different method for tuning VE such as Autotune or AMC? If it matters, I have individual throttle bodies. Thanks for any help.
You do not have the required permissions to view the files attached to this post.
Gary
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Odd pattern in my VE table
The only really strange area on the map is the high kPa - low RPM area. It may not be getting enough data there and is probably overcompensating if it's not allowed to tune below 1000 RPM. I would dial those in by hand.
