Hi! i got a problem.6 cyl porsche engine MS1 V3 board. injektors high impedance.settings 2sqirts per cycle and alternating.
cyl bank1 runs good but bank 2 not.changing cables bank 1 to bank 2 and vs.then bank 2 runs good and 1 runs poor.disconecting each one at the faliure bank and idling on the good bank.when ill disconecting one injektor from the proper bank engine react direktly. testing to spray fuel in to the faliure bank and engine rews up.Ill kan hear and feel all injektors klicking by connect a singel test injektor in each connector at the harness.Checking wiring and ground. 14v to the injektors.tried to change Q1 at the board whith no success. anybody have a tip??
Best regards. Swede
cyl bank 1 and 2 dont runs equal!
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
MustangSix
- MegaSquirt Newbie
- Posts: 7
- Joined: Thu May 27, 2004 4:46 am
Re: cyl bank 1 and 2 dont runs equal!
Try running both banks from the same good output. Set control to simultaneous, 1 or 2 squirts.