I just got these
Wideband Innovate:
MS-II V3.0
Now, I'm installing this on a 1.8T 20V, with COP's and will not use an idle valve.
I've been told by a friend that I should skip step 50, as I'm not using a distributor.
Anything else?
Cheers!
Got my MS-II V3.0 pack. Will assemble shortly. Tips?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Got my MS-II V3.0 pack. Will assemble shortly. Tips?
Hi!
I just got these
Wideband Innovate:
MS-II V3.0
Now, I'm installing this on a 1.8T 20V, with COP's and will not use an idle valve.
I've been told by a friend that I should skip step 50, as I'm not using a distributor.
Anything else?
Cheers!
I just got these
Wideband Innovate:
MS-II V3.0
Now, I'm installing this on a 1.8T 20V, with COP's and will not use an idle valve.
I've been told by a friend that I should skip step 50, as I'm not using a distributor.
Anything else?
Cheers!
Re: Got my MS-II V3.0 pack. Will assemble shortly. Tips?
Don't forget to ground the wideband to the same termination point as the Megasquirt. And if you take power from the same fuse you wont be able to run the engine with out having power to the O2 sensor. This can plug up the O2 sensor.
88 Dakota 2.2 5SP
95 5.2 Magnum
94 A518 O/D
74 electronic ignition
2.2 megasquirt
95 5.2 Magnum
94 A518 O/D
74 electronic ignition
2.2 megasquirt