A little background, I am helping a friend install MegaSquirt on his vehicle and am new to working with multiple projects. If there is anyplace I can go to read up on how to best do this, I would appreciate it.
I created a new project for this vehicle and select it. When I select the new project I get a warning that reads:
Failed to subscribe DashComp to OutputChannel TPS DecelOC
Please set to a valid OutputChannel
the warning box also has these lines for TPS AccelOC, ReadyOC, FLOOD CLEAROC, MAP AccelOC, ASEOC and WUEOC.
When I select the project for my vehicle, I do not get this warning. Both boxes are MS2 on V3 boards. I did a fresh load of the 2.890 code on my friends MS so we are both running the same code.
What can I do to fix this warning? Thanks. Brian
Failed to subscribe DashComp to.... warning
Moderator: LT401Vette
Failed to subscribe DashComp to.... warning
MS2 code2.89 on PCB v3.0
-
LT401Vette
- Master Squirter
- Posts: 481
- Joined: Sat Jul 16, 2005 7:07 am
- Location: Charlotte, NC
- Contact:
Re: Failed to subscribe DashComp to.... warning
It sounds like you have a dash for a different firmware.
Right click on the dash and select Load / Save dash
Right click on the dash and select Load / Save dash
Phil Tobin
EFI Analytics, helping to simplify EFI with Next Generation tuning software.
http://www.tunerstudio.com/
http://www.efiAnalytics.com/MegaLogViewer/
Android Shadow Dash MS: http://tunerstudio.com/index.php/shadowdashmsmenu
EFI Analytics, helping to simplify EFI with Next Generation tuning software.
http://www.tunerstudio.com/
http://www.efiAnalytics.com/MegaLogViewer/
Android Shadow Dash MS: http://tunerstudio.com/index.php/shadowdashmsmenu
Re: Failed to subscribe DashComp to.... warning
That did the trick. Thanks.
Brian.
Brian.
MS2 code2.89 on PCB v3.0