Hello.
I am wiring up a MS2 v3.57 up to my 1993 EEC-IV harness via DIYBOB.
The MS2 harness has 6 black ground wires.
My EEC-IV has the following grounds - Case Ground (pin 20), Power Ground (pin 40), Power Ground (pin 60).
I believe all 3 of the EEC grounds go to the chassis. Do I put two MS ground on each EEC ground?
Thank You
Adam
Grounds?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Grounds?
That should work.
-
FordTaurusGuy
- MegaSquirt Newbie
- Posts: 18
- Joined: Thu Apr 21, 2011 6:28 pm
Re: Grounds?
Thanks.Matt Cramer wrote:That should work.