Hi,
I have a question regarding the relay board. I have a V8 with 2x4 injectors bbench (1 for each cylinder). I have wired it to INJ1/INJ2 in relay board and INJ2 was not working.
I realized that there´s INJ1/INJ1/INJ2/INJ2 in the board so when I pluged INJ1/INJ1 both benchs worked. Is this correct?
Regards,
Relay board injectors
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Relay board injectors
1973 Brasilian Dart megasquirted
Re: Relay board injectors
There are two injector drivers inside MS. Each one goes to two terminals on the DB37 connector. Inj1 to 32&33, Inj2 to 34&35. Two terminals are needed as the maximum current can exceed what one DB37 pin can handle.
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Re: Relay board injectors
Ok,
so if my INJ2 was not working this could be due to a burnt transistor? Which one drives INJ2? Know the circuit part number?
- Maybe if I turn 8 injector into 1 drive this could burn this transistor algo correct? Too much current...
Regds,
so if my INJ2 was not working this could be due to a burnt transistor? Which one drives INJ2? Know the circuit part number?
- Maybe if I turn 8 injector into 1 drive this could burn this transistor algo correct? Too much current...
Regds,
1973 Brasilian Dart megasquirted
Re: Relay board injectors
There are schematics for all the various PCBs in the manual. Refer to the appropriate one and find the injector drivers. That gives the component number and part number.
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Re: Relay board injectors
Hi all,
Thanks for your input. Q7 had a broken pin. Soldered and its working.
Rgds,
Thanks for your input. Q7 had a broken pin. Soldered and its working.
Rgds,
1973 Brasilian Dart megasquirted