I am redoing the cooling system on one of my racebikes, and need to replace the coolant temp sensor.
Ideally, it would be the standard GM temp curve that MS likes, and 1/8" NPT threads.
Anybody know of one that fits the bill?
Lots of searching on the forums/megamanual has turned up a 1/4" NPT, but that is a bit large.
sensor sourcing
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
BrentP
- MegaSquirt Newbie
- Posts: 4
- Joined: Wed May 05, 2004 8:20 am
- Location: Shoreline, WA, USA
- Contact:
Re: sensor sourcing
Thx for the pointer, I have sent mail to them asking about them. Looks like it might be a special order item.
I may just end up using the sensor that came with the thermostat housing, and try to remember to recalibrate when I burn code. Don't want to change the bias resistor.
I may just end up using the sensor that came with the thermostat housing, and try to remember to recalibrate when I burn code. Don't want to change the bias resistor.