How to know the correct InjOpen Time ?
I start my engine with the advocated value (1.0ms) but Idle speed is smoother with 3ms.
How can I determine the "correct" value ? Measure ? Calculation ?
Txh@all
Pat
Injector Opening Time
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Injector Opening Time
Unless you are running LPG injectors, 3 ms is likely too long - I'm guessing the idle smoothed out because you weren't adding enough fuel earlier. Set the opening time to 1 ms and adjust the idle with the VE table. Then change the number of squirts and see what happens to your AFR. If it goes richer, decrease the opening time; if it goes leaner, increase it.
Re: Injector Opening Time
Thx U Matt.
No I run pump gas Injector (from VW mexican beetle).
I think that my NB send bad value or may be not function correctly because I read on MT 0.45/0.5v on EGO meter but the exhaust gas mixture feel rich.
No I run pump gas Injector (from VW mexican beetle).
I think that my NB send bad value or may be not function correctly because I read on MT 0.45/0.5v on EGO meter but the exhaust gas mixture feel rich.
-
john.p.clegg
Re: Injector Opening Time
Matt
Just to clarify,which way do you adjust the number of squirts up or down?
Thanks
John
Just to clarify,which way do you adjust the number of squirts up or down?
Thanks
John
Re: Injector Opening Time
I beleive he thinks to increase from 1 to ....
4 squirts being for smoother idling.
4 squirts being for smoother idling.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Injector Opening Time
Should have cleared that up - I meant increase the number of squirts. If you decrease them the AFR will go the other way.john.p.clegg wrote:Matt
Just to clarify,which way do you adjust the number of squirts up or down?
Thanks
John