MSefi.com read only forum (Jan.15,2018)

Hello, my question is:
Im using an MS2 v3.57 (without coil driver) and im going to change it to an MS2 v3.0 (whith coil driver) May I use the same harness or there is some difference between them?

Regards
DC

The harnesses don't generally depend on the main board, other than what you've hooked to pin 36 since you said you're adding a coil driver. Unless you've got something coming out on the DB15, as that's not normally present on a V3.0.

Thanks Matt, pin 36 im using it to Rpm signal ((-) coil) and in the DB15 nothing connected.

regards

DC