MSefi.com read only forum (Jan.15,2018)

Posted: **Tue Feb 24, 2009 5:38 pm**

I see that you can use the VR circuit with a Hall Sensor, my question is how do you wire the hall sensor and how many volts do you send to it? I'm using a VW crank hall effect sensor. Please help.

Posted: **Wed Feb 25, 2009 4:50 pm**

Within this thread I believe it says 5v or 12v, depending on the output level you want: http://www.microsquirt.com/viewtopic.php?f=87&t=22790

But check the datasheet for your sensor -- it may restrict the voltage you use. And the datasheet will likely tell you how to wire it up.

Brian

Posted: **Thu Feb 26, 2009 9:01 pm**

Thanks Brian I appreciate your help on this.

MSefi.com read only forum (Jan.15,2018)

Using the VR circuit with a Hall Sensor?

Using the VR circuit with a Hall Sensor?

Re: Using the VR circuit with a Hall Sensor?

Re: Using the VR circuit with a Hall Sensor?