Alright, so since my post got removed from here for using the ms2/extra, I went ahead and swapped it back to the ms 2.687 and am still having the same issues. As soon as I hit the gas, it tries to stall, if i SLOWLY push the gas in, it tries to rev to about 2k, then starts sputtering. I get lean spikes when I let off or as I do it. I have read the megamanual section, I did fool around whith the accell wizard, turning it way up, then way down, tried in between, all did the same thing. I did re-install firmware etc, etc.
So since now I have done all that, and Matt Cramer feals I need to ask a "real" question, what do I need to be looking into now, after trying all that?
MS2 3.57 board
89 TT Camaro, 350sbc TPI
32lb injectors
pre-built setup through DIY...
Thank you
stalls when accelerates..
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.