MSefi.com read only forum (Jan.15,2018)

Hi All..

I have just installed a MSII with V3 board and the newest MSE firmware..
3 things dont work when i connect it to my car.

1. Is the hall sensor (but i found out i needet a pulldown resistor so i have just mounted that). i hope that solved it..

The other 2 things is my IAT and CTS, they both start at around 130degrees C and drop very slowly to around 80Degrees C.
The inputs dont even work if i make a test setup on my table with a variable resistor.

I have used the megatune to se the tables after the values i have measured on the IAT and CTS..

Have any of you seen anything like it?

i really hope you can help.

Kind regards
Morten

HAHA Never mind

I found the error after doing som mesuring, i spotted that i had forgot to mount R5 and R8

Everything works now