High Current Ignition Driver
Posted: Thu Mar 26, 2009 4:58 pm
Hello-I am finishing up my first MS II 3.0 board. I am using GM HEI with a MSD 5/Accel coil on a 4.3 v6. Is there any reason to use the high current ignition driver? Is it better? I will be switching to a Ford EDIS system later. Will this cause me any problems? Can I easily switch back to using the 8 pin HEI module if need be? Just trying to sort this out in my head. Want the system to be the best it can be. Thanks!