MLV question
Posted: Mon Apr 20, 2009 8:19 pm
I've discovered that I have not been using MLV properly for analyzing my VE table. One of the steps in the MLV HELP for VE Analysis instructs to open the MSQ file, but when I try to open the MSQ file using MLV, it does not look for MSQ files, so I wrongly assumed that it was reading my msq file when I had Megatune opened at the same time. I think this is bad flaw with MLV. Anyway, after I did figure out how to open my msq file in MLV, it gave me the following message:
'The Y axis fields "MAP" not found in current datalog. Set the correct Y axis field from the Options menu for table highlighting and VE Analysis to work correctly."
So when I go to "Options" in MLV and then "Y axis field", in right options, the right arrow points to several options and I don't know which to choose. The options are MAP (which already had a check mark in the box), TP, TP ADC, TPS 8Bit, and Other. Which one should I choose to make MLV work for me?
Thanks for the help.
Gary
'The Y axis fields "MAP" not found in current datalog. Set the correct Y axis field from the Options menu for table highlighting and VE Analysis to work correctly."
So when I go to "Options" in MLV and then "Y axis field", in right options, the right arrow points to several options and I don't know which to choose. The options are MAP (which already had a check mark in the box), TP, TP ADC, TPS 8Bit, and Other. Which one should I choose to make MLV work for me?
Thanks for the help.
Gary