MSefi.com read only forum (Jan.15,2018)

Posted: **Sun Jul 12, 2009 5:44 pm**

Where is a good place to pick up the switched 12V for the EDIS module? I didn't want to use the same source as the +12V switched power for the relay board since the EDIS switched 12V powers the coil and so forth. It was suggested to use the injector +12V terminals on the relay board, however, reading another post, I see that method caused someone's engine to continue running after the key was turned OFF.

Any help? Thanks in advance.

Posted: **Mon Jul 13, 2009 5:20 am**

You can run a separate relay that is turned on by the same power source as the 12 volt switched to the relay board.

MSefi.com read only forum (Jan.15,2018)

Where to get power for the EDIS module?

Where to get power for the EDIS module?

Re: Where to get power for the EDIS module?