Page 1 of 1
92 mustang gt dash wiring diagram
Posted: Mon Jul 27, 2009 5:25 am
by RACEME
I have ordered the diy package for the megasquirt II (including 12' engine harness pigtail). The old engine compartment harness from the EEC is junk/cut up so I am scraping it. There are 3 connectors that attached to the engine compartment harness inside the car that I want to know about on the dash side of the connectors. There is a Grey connector that has 4 wires, and there is the green 8 pin connector. there is also the black one for the EEC power relay. Is there a diagram someplace that shows these wires?
Re: 92 mustang gt dash wiring diagram
Posted: Mon Jul 27, 2009 6:09 am
by RACEME
I found the green 8 pin diagram.
I still need the what the EEC power relay wires do. They are Yellow, Red, Black w/White stripe, and Red w/Green strip.
I also need the Grey connector with 4 wires. They are Pink/orange, Pink/white, Purple/green, and Purple/blue.
Re: 92 mustang gt dash wiring diagram
Posted: Mon Jul 27, 2009 6:46 am
by Matt Cramer
Often, the relay pinout is written on the relay itself.
What exactly does the gray mystery connector plug into?
Re: 92 mustang gt dash wiring diagram
Posted: Mon Jul 27, 2009 6:55 am
by RACEME
Matt Cramer wrote:Often, the relay pinout is written on the relay itself.
What exactly does the gray mystery connector plug into?
Not sure. It is in the kick panel and I have not traced it down. I was hoping for an easy answer to weither or not I need to use those wires for anything.