MSefi.com read only forum (Jan.15,2018)

Oke, im trying to test my injectors..

First i tryed with the standard 400/20/60 [(squirts)/(pw)/(close)] I did burn it to flash. worked well.

After some test i would try a verry short closingtime. So i set the parameters to 100/50/1 and also burn it. I noticed that ms didnt do anyting, he still used the last test. burn to flash again and then it did. Fist time a short puls from the injector, seems to work. But the next test i did, the injector stays open without giving a pulse and stays squirting (till i am running out of fuel?).

Now i dont get it out of the testmode, the injector stays open all the time. Even when i set te squirt to 0 it wont work..

Problem solved.

a reboot fixed it.. i could not burn to flash anymore. I gues i've set the pw too short, so it was squirting continuous. Afther that i made a mistake, i was turning it on to 'normal mode' and burned it. Result: I could not burn anyting anymore.

After the reboot i tryed the short pw again and it also was squirting continuously. When i set the pw up to 5 it was squirting with pw. Then i turned it back to normal mode and immediatly it turned back to normal mode. (This never happend before)

I Didnt try to set it to normal mode after the continuously squirt, becouse i was afraid to reboot again..