MSefi.com read only forum (Jan.15,2018)

I am trying to do my conversion in a phased approach so I have fewer systems to figure out all at once. Can I use an MS-II with EDIS and only control the spark? Once I get that working with my carb I can do the fuel side and not be trying to dial them both in at the same time. Good idea or waste of time since I will want to tune the ignition and fuel together eventually? I am just thinking about start up and getting it running easier.

Big block Chevy
Enderle IR manifold
MS-II
Ford EDIS
52# ZR1 injectors

Sure, that will be easier than trying to make everything work at once. The MS2 won't care that its injector drivers are disconnected.