MSefi.com read only forum (Jan.15,2018)

I just got my MS-II running from the MS-I extra code and noticed my accel enrichments look kinda weird. Those #'s look real high. Is it because of the v/sec and the %/sec etc change? If it was running great like I had it in the extra should I just change the settings? I noticed in the manual that it goes up to 200 and mine only goes up to 100

And my 'TPSdot Threshold' doesn't have a % beside it either

MS-II(below)



My old Extra codelooked like this(below)



From the manual:(below pic)

How did this post get moved to the MSXtra forum? I'm not running the xtra code?

Please include your code type when asking for tuning advice. Note that your signature says:

MSnExtra July/06 EDIS Aug/06

Forum Admin Team

Those values do look pretty high compared to the old ones. A rate of 15.1 volts per second would probably be more like 400% per second on a normal TPS.

Matt Cramer wrote:Those values do look pretty high compared to the old ones. A rate of 15.1 volts per second would probably be more like 400% per second on a normal TPS.

Thanks for the feedback. It did look real high. I wonder why it was like this from the factory settings?

Those were like that from when I opened it up for the first time.

Is there a conversion from volts per second to % per second?

panel wrote:Is there a conversion from volts per second to % per second?

To get from volts/sec to %/sec, take the volts/sec value, divide it by the difference between voltage at WOT and voltage at closed throttle, multiply it by 100%.

Thanks again Matt. It's coming a lot more clear to me. Hopefully the last question here..........

Is it just as simple as turning my 'TPS gauge' into volts (Megatune) to get this or is there a conversion from 'TPS ADC count value' into 'Volts'?