MSefi.com read only forum (Jan.15,2018)

Hi!
I just got these

Wideband Innovate:



MS-II V3.0



Now, I'm installing this on a 1.8T 20V, with COP's and will not use an idle valve.
I've been told by a friend that I should skip step 50, as I'm not using a distributor.
Anything else?

Cheers!

Don't forget to ground the wideband to the same termination point as the Megasquirt. And if you take power from the same fuse you wont be able to run the engine with out having power to the O2 sensor. This can plug up the O2 sensor.