A friend of mine who do hill climbing race have a problem with an usb/serial adapter
This week end is it the race and we have'nt got time to repair the connection before he lefts for the race .....
Of course he haven't an internet connection on the race.
Just after a race session, he has problem on WOT, the engine run poor.
He connects his adapter to the MS but MT don't connect ..
Before that everinthing was ok, connection, communications, log, setting the VE table etc ...
The engine ran great.
We think about a MAP problem. Map sensor or on pipes to the map sensor.
He checks all pipes at this time, during I try to solv the communication problem at 700kms ...
So, Windows XP recognize the adapter on the COM15.
Adapter is set like that :
but when he takes a look, he hits the default setting button. After that communication was lost.
Could you tell me what is your setting on the advanced sheet on the serial adapter properties ?
Of course MT connection settings are set on the right speed and right COM.
Thx a lot
Pat
