Page 1 of 1
Precision Wideband controller
Posted: Sat Oct 29, 2011 5:10 am
by Fueler
Never sure where to post as there are so many forums for MS. Give it a go here.
I have been reading about the PWC but don't see it offered for sale anywhere.
http://www.megamanual.com/PWC/indexright.htm
Is it available, work in progress or a dead player?
Thanks
Re: Precision Wideband controller
Posted: Mon Oct 31, 2011 8:34 am
by Bernard Fife
Fueler,
Apparently Bruce continues to work on this, and it isn't too far from release, if Bruce could find the time to work on it. He was going to do an update at the Portland meet (which was canceled because of travel issues and illnesses), so perhaps he will do an update here. You might try PM'ing him (he is user Bruce Bowling:
memberlist.php?mode=viewprofile&u=6 )
Lance.
Re: Precision Wideband controller
Posted: Mon Oct 31, 2011 12:40 pm
by Fueler
Thanks, I was getting down to the point of needing to choose a dual WB controller and hoped this one might be ready for primetime.
Back to flipping coins on the others.
Re: Precision Wideband controller
Posted: Tue Nov 08, 2011 10:02 pm
by Philip Lochner
I've been using Innovate LC-1 but I have also found that these DO NOT like to be powered up while cranking. I now install them so they only get power once the alternator starts charging using the D+ output to energize a relay which then feeds power to the LC-1. Innovate also has a new WBO called MTX-L of which I have no experience yet.