Tunerstudio Setting For "Fuel Only"

For discussing Phil Tobin's TunerStudio MS is the MegaSquirt edition of TunerStudio, a next generation tuning application. It provides the ability to configure and tune all MegaSquirt controllers and is 100% compatible with MegaTune ini files and msq's.

Moderator: LT401Vette

Forum rules
Post Reply
jonboyb
MegaSquirt Newbie
Posts: 2
Joined: Mon Apr 03, 2006 8:01 am

Tunerstudio Setting For "Fuel Only"

Post by jonboyb »

Been running EDIS for years and just did a fuel only install on another vehicle. Can't figure out what to set in Tunderstudio to just pull RPM from the (-) coil. I have MSII v 3.0 running 2.89. From reading some code seem to have a "fuel only" selection in the ignition setup menu but I can't find it.
Top
Bernard Fife
Master Squirter
Posts: 475
Joined: Thu Oct 29, 2009 12:54 pm

Re: Tunerstudio Setting For "Fuel Only"

Post by Bernard Fife »

jbb,

There is no such setting in B&G codes. If you don't want to control ignition, don't connect the ignition output. It is as simple as that.

Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw
Top
Post Reply

Return to “TunerStudioMS”