EDIS-6 donor vehicles (USA)?

[Adnan]

Hi,

In searching this forum, I see that 91-95 Explorers used EDIS-6. What other vehicles and model years use the same?

Also, I've read that some use a flywheel VR sensor - would this same sensor be suitable for a typical crank pulley type trigger wheel? Ideally, if anyone knows of a vehicle that used EDIS-6 with a crank trigger, that would be ideal. Oh, and location advise as to where the thing is tucked away would be a bonus.

Thanks for the help!

[Matt Cramer]

Aerostars from the same vintage - look on the fender.

[trakkies]

I'd be surprised if the trigger electrics varied for any EDIS set-up, so it should just be a case of choosing one which fits your application.

[Adnan]

Aerostars from the same vintage - look on the fender.

Thanks Matt,

What about Rangers? Didn't they share a lot of drivetrain bits with Explorers?

[kjones6039]

According to my quick search at Summit Racing, EDIS6 was used on Ranger's from about 1989 through 2000, or there about.

Here's a link that may help.

http://www.summitracing.com/parts/ACC-1 ... del|RANGER

As you can see they are not terribly expensive. It might be worth it to buy one new rather than searching the wrecking yards.

Ken

[kjones6039]

OOPS.....

That link, of course, is just for the EDIS6 coil, but the link is still useful to find which vehicles used EDIS6.

Apologies for not making that clear in my reply.

Ken

[Adnan]

OOPS.....

That link, of course, is just for the EDIS6 coil, but the link is still useful to find which vehicles used EDIS6.

Apologies for not making that clear in my reply.

Ken

Ken,

Thanks for the input. Some good information at the link.

Regards,
Adnan