injector resistor
Posted: Thu Jul 19, 2012 1:09 pm
My MS has been running on the run stand and am now going to put it on my suburban which has tbi. I want to leave the gm computer operational so that I can switch it back to stock when I am happy the MS is set up right. I will put it on my hotrod and put the burb back to stock. My plan is to use a 4 ohm resistor on the gm wires which should make the gm ecm think it is doing its job. My question is what wattage should I use for the 4 ohm. You can probably tell I am not an electronics guy, I just follow the directions.