MSefi.com read only forum (Jan.15,2018)

i have a ms2 and i want to useit as fuel only for now
im useing tuner studio and have no clue how to set up

whats hooked up

tps
clt
iat
inj.
o2
and signal from crank trig
60-2

i remember seeing once that is said Fuel only in the setting and i no longer see it
ive been reading the manual i even printed it to read at work on my lunch break and im sick of it
i just need some one to point me in the right direccion either to a specific part of the manual to re read
or some one to just plain out tell me im a confused person ..

PKDoo,

If you want fuel only, just don't hook up the ignition output. You don't need to do anything else with the hardware. You will have to set up the hardware for your 60-2 wheel, of course. For that, see:

http://www.megamanual.com/mt29.htm#ia

and:

http://www.megamanual.com/ms2/wheel.htm

Lance.

ok so im good on the crank sig i did all the settings ect.

my next question is why am i getting like 4000rpm on crank ?

i havent put power to inj yet so i havent tryed to start

im trying to get evrything else reading properly before i start the engine

evrything else is good except for the 4000rpm while cranking

yay after reading more i fot the settings right now rpm is on key

but and why is there always a but lol

the rpm goes to 0 at times like it looses the signal ive read something about useing a cap to smooth it out
or again am i a confused person lol

Payko0o wrote:yay after reading more i fot the settings right now rpm is on key

but and why is there always a but lol

the rpm goes to 0 at times like it looses the signal ive read something about useing a cap to smooth it out
or again am i a confused person lol

Please post a data log of an attempted start and a copy of your MSQ file. That should give us more to go on.