Page 1 of 1
Input for advance gauge in TS
Posted: Sun Aug 19, 2012 5:16 pm
by floppy
Where does TS get its info for the spark advance gauge?
Having issues and am looking for clues. The issue is at:
viewtopic.php?f=89&t=41627
MSII, 2.905
Re: Input for advance gauge in TS
Posted: Sun Aug 19, 2012 5:31 pm
by LT401Vette
The actual value that it displays comes pretty much straight from the firmware. It displays what the firmware returns in the runtime data.
Re: Input for advance gauge in TS
Posted: Sun Aug 19, 2012 5:48 pm
by floppy
Hmmm, I'll reburn the firmware again.
Do you think there is any issue with burning over your bluetooth adapter? it is quite a bit slower than the rs232 on my old laptop. Is there a preferred location to save the downloaded file for burning with the downloader?
Re: Input for advance gauge in TS
Posted: Mon Aug 20, 2012 4:49 am
by LT401Vette
You should be Ok loading firmware over BT, I have done it. But it is not well tested and would suggest using a cable, pay attention to the verification the loader does after loading. Use BT at your own risk, and make sure you keep the laptop in close range while it is uploading.