newbee,reset?

[phred017]

is there a reset to defalts? ive got my car to run but ive adjusted too many things. if there is a way to reset defalts, i think i would be better off starting over.(4.3 throttle body) thanks

[kjones6039]

Assuming TS, you can fall back to an earlier Restore Point. Otherwise you can reload the base msq or, of course, you could also reload the firmware.

Ken

[phred017]

I had the thing running fairly well, the first trip down the road it ran good through 1st gear,second gear, then i had to let off and it promptly fouled several spark plugs. the biggest problem im having is fuel(fouling spark plugs, fuel in oil)

[kjones6039]

I had the thing running fairly well, the first trip down the road it ran good through 1st gear,second gear, then i had to let off and it promptly fouled several spark plugs. the biggest problem im having is fuel(fouling spark plugs, fuel in oil)

Did you log that?

msq and log would be most helpful.

Ken

[phred017]

i can get the vega to crank any time, it will crank up run a few min. foul out plugs. when it does this the oxy sensor goes wild and it dumps fuel in the oil, what should my injecter settings be? what should i start with, im tired of changing oil (4.3 throttle body)

[kjones6039]

I hate to be redundant but....... Post your msq and a log of the behavior.

Just saying it fouls the plugs isn't much to go on.............

Ken

[phred017]

ok im working on adding MSQ and datalog, had better results today,thanks.