I tested my mega squirt using Tuner Studio and the stim. Everything works. I am at a point where I want to setup my software for my project. I have found lots of information/support for Mega Tune but very little for Tuner Studio. My firmware is MSII REV 2.90500.
Which is the best choice for a beginner?
Also, when I tried Mega Tune it has controller code mismatch. Where can I find the correct .ini for the MSII REV 2.90500
Thanks for any help.
Which tuner software to use
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Which tuner software to use
1970 Honda N600 600cc Twin
-
kjones6039
- Master Squirter
- Posts: 618
- Joined: Sat Jul 22, 2006 7:02 pm
- Location: Eureka, Nevada USA
- Contact:
Re: Which tuner software to use
MT is pretty much a thing of the past! To the best of my understanding, it is no longer supported!
I suggest just continuing with TS......
IMO, of course...........
Ken
I suggest just continuing with TS......
IMO, of course...........
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/ms2extra 3.4.0 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
MS2 v3 w/ms2extra 3.4.0 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
Re: Which tuner software to use
Thanks again Ken. I just found a TS setup article at DIYAutoTune.com. I think this should get me started.
1970 Honda N600 600cc Twin