Page 1 of 1
Manifold Air Pressure Sensor (MAP) for Megasquirt 1 V3.0
Posted: Fri Mar 29, 2013 12:52 pm
by 2013T
I have been looking at the wiring for the megasquirt 1 V3.0 main board and there is no place for the MAP sensor. Does this board not use a MAP sensor?
Re: Manifold Air Pressure Sensor (MAP) for Megasquirt 1 V3.0
Posted: Fri Mar 29, 2013 4:24 pm
by DonTZ125
The MAP sensor is on the circuit board, not remote. Instead of having a flying sensor close to the manifold with a short hose and long wires, the MS uses a long hose and no wires.