MSefi.com read only forum (Jan.15,2018)

i am building the V3 board with EDIS, this is my 4th one the other 3 i done MSextra with no problems, after built and with mods for EDIS placed an MS!extra chip and tested fine with simulator, but when i place the ms2 chip the fuel pump led just flashes, the MS2 chip has the software 2.920, then i replaced with other MS2 chip loaded with 2.905 and this one makes the fuel injectors led flshes rapidlly for 30 sec or so then quit even if i have no engine pulses from the simulator, any sugestions, thanks for the help

Have you set the MS type? Fuel Settings - General. This needs to be done between MS1 and MS2.

with the MS2 chip loaded with 2.905 , it let me open tuner studio and check it and it shows ms2

thanks trakkies , that was the problem, finally i got it to start,