MSefi.com read only forum (Jan.15,2018)

Hi, I have a ms2 v3 and i am having issues with the first start up. When I turn on the key all 3 leds flash and then d14 stays on. I do not seem to have any injector pulse. There is power to the injectors I have tested that and i have ran an injector test with no luck. In tuner studio I have rpm on the gauge when cranking and i also show pulse and duty cycle but it will not start unless you spray starting fluid in it then it will run until that is gone. if some one can point me in the right direction that would be greatly appreciated. i dont have a data log yet but will get one tomorrow.

thanks
mike

Nevermind guys i have solved my own problem. going back over everything in the tune i found thayt i had selected microsquirt instead of ms2.