MSefi.com read only forum (Jan.15,2018)

Hi Again

I just got my new cpu from Al [old one exploded] today!!! I plugged it into MS and hooked up stim. Every thing appears okay but CLT & IAT will only go from 38 deg to 170 deg this is with volts of 0 to 4.00vdc @ ad2-1 the r8 reads 2.19k. I have 10vdc in to stim. I poked around with the vom [which is by no means calibrated] and r7 and r4 read totally different and neither reads 2.49k both low. Are the temp readings normal on the stim? I can't find any reference to what gauges should read on the stim.

THANK YOU LANCE

I was sitting here with soldering iron in hand ready
to replace every thing in the circuit but I guess I plug
it into car and seeing what happens next.
Thanks again

Got that right !!! Anyway MS is up and running fine. Added fast idle solenoid with relay and replaced IAC with fabricated idle adjustment which I have to say works quite well. Need some more time tuning cold start band warm-up.
Thanks again ! Because without you guys and this MS unit my project was dead in the water and headed to a recycling yard...