MSefi.com read only forum (Jan.15,2018)

How do I use easytherm to allow me to use chrysler sensors? Where do I find out the resistance of the sensors without actually measuring it myself?

turbosundance wrote:How do I use easytherm to allow me to use chrysler sensors? Where do I find out the resistance of the sensors without actually measuring it myself?

The basics are covered here:

http://www.megasquirt.info/manual/mwire.htm#et

and specifics in the readme file included with the EasyTherm distribution.

Sensor data can be found typically in the shop manual for the vehicle in question, or by measuring the sensors themselves.

Roger

I was actually hoping someone knew the umbers and could just tell them to me It's for an 87 sundance turbo

I just chucked the chrysler sensors and used some gm ones from the wreckers. Screwed in the same holes and the connectors were exactly the same. Problem solved